The HZ‑SWEX is a Horizon™ in‑wall switch that controls incandescent, magnetic low voltage, and tungsten‑halogen loads as well as electronic ballasts and 1/2 HP motors. Its design matches the entire line of Horizon dimmers, switches, and keypads, making it a great addition to new or retrofit installations.

NOTE: Faceplates are not included. Refer to the HZ‑FP‑G series faceplates for more information.

Integrated Keypad
Supporting up to five buttons, the HZ‑SWEX is configurable for a variety of applications. Because the switch is attached to the Crestron® network, it can function as a keypad to trigger remote actions.

Multiway Control
The HZ‑SWEX supports load control from multiple locations. Up to four HZ‑KPEX or HZ‑AUX devices¹ can be connected to a traveler wire in a traditional three- or four-way circuit to switch the load attached to the HZ‑SWEX. The HZ‑KPEX provides backlit, engravable button caps for multiway control, while the HZ-AUX provides a single large rocker button.

Multigang Expansion
Up to four devices may be installed side‑by‑side in a multigang electrical box with a compatible Horizon faceplate (HZ‑FP‑G series).¹ All buttons in a multigang arrangement align to form one continuous control surface.

infiNET EX Communications
infiNET EX wireless technology provides two‑way RF communications throughout a residential or commercial structure without the need for physical control wiring. Each infiNET EX device acts as an expander by sending command signals to other infiNET EX devices in range (approximately 150 ft (46 m) indoors) to ensure reliability and stability.²

The HZ‑SWEX communicates with a control system via a CEN‑GWEXER¹ or newer infiNET EX Wireless Gateway. Up to 100 infiNET EX devices may coexist on a wireless network.

Field-Replaceable Button Caps
The preinstalled rocker button cap on the HZ‑SWEX is field replaceable, allowing for engravable multi‑button configurations.

Multicolor Backlit Button Engraving
Horizon button caps are laser engravable to identify each button's function. RGB LED backlights illuminate the engraved labels and can be adjusted for custom color backlighting. A built‑in ambient light sensor enables auto‑dimming of the backlight brightness according to day and night mode presets.

Each button's backlight provides feedback by changing color, intensity, or both. The backlight can also flash to show that an action is being performed.

Customizable Faceplates
Horizon device faceplates (sold separately) are customizable for any décor. Color‑matched top and bottom trim pieces may be swapped easily after installation with custom trim fabricated from solid materials such as wood, metal, marble, engineered stone, or Corian® solid surface. Contact a Crestron representative, or refer to Crestron True Blue Support Online Help Answer ID: 1000140, to obtain specifications and CADs for the fabrication of custom trim. Paintable trim is also available separately.

Note: The faceplate trim is attached magnetically, which may inhibit use in locations where tampering may occur.